power station waste heat recovery

Industrial boilers

Product thermal capacity: 4-35 t/h

Working pressure: 1.0-2.5 MPA

Outlet temperature: 184-350 ℃

Available fuel: natural gas, coke oven gas, bio-gas,liquid propane gas, diesel, heavy oil, light oil, crude oil

Available industries: Petroleum, chemical, chemical fiber, pharmaceutical, textile printing and dyeing, building materials, wood processing, vegetable oil processing and other industries

  • Product introduction
  • Technical advantages
Introduction

power station waste heat recovery have a three-pass round coil structure. A conical coil is used for the effective protection of the furnace wall at the boiler end. This product is equipped with an advanced combustion device and is fully automated in operation. After the burner ignites the fuel, flame fills the round coil tubes and transfers heat by radiation through the tube wall (first pass). The high temperature flue gas gathers at the back door and then turns to the convection tubes section (second pass), where heat transfer takes place by convection. The flue gas gradually cools down here and flows to the front door, where it is reversed and goes into the third pass. After that, it enters into the chimney through the economizer and is released into the atmosphere.


power station waste heat recovery.This type of heater is delivered as a whole, and is installed on site, it only needs to connect thermal gas(oil) piping and electricity to start operation. The heater has four heating areas: furnace radiation heating area, the first convection tube bundle heating area, the second convection tube bundle heating area and economizer (waste heat boiler).

Digitized manufacture
  • The laying-off of steel tube adopts CNC 3D laser cutting machine.
  • The manufacture of round coil tube adopts CNC coil tube automatic production line. Once-forming and no need for plastic .
Full argon arc welding
  • The tube butt adopts argon arc welding technique and the seams will be done x ray real-time imaging, preventing unqualified seams from entering coil production line .
Easy operation
  • Heater is wholly assembled before delivery, it is easy for installation, debugging and operating.
  • Fully automatic operating, burning, liquid level of high level tank, outlet temperature and flow rate are adjusted automatically and self-protected.
  • The inlet and outlet with end flanges and flanged cover structure facilitate the installation and layout of tubeline in boiler house.
Less fuel consumption
  • Internal side adopts good insulation material, outside uses stainless steel plate, which can mostly reduce heat lost and make working environment better.
  • Multilayers closely spaced tube bundle and steel rod is used to seal and fix, completely eradicating short circuit of flue gas.
  • Before delivery, the residue moisture is removed completely, so the system draining period is reduced to 2 days from 12 days.
Safely operation
  • The inner coil tube has bigger flow rate, so it is more stable under high temperature operation.
  • Conical coil effectively protects the furnace wall at the end of heater and burner on the top.
power station waste heat recovery power station waste heat recovery power station waste heat recovery

Demonstration of Waste Heat Recovery for Power

Prepared by: Energy Research and Development Division FINAL PROJECT REPORT Demonstration of Waste Heat Recovery for Power Generation MARCH 201 5 CEC-500-2015-066 Prepared for: California Energy Commission

lexie@zozen.com > Get A Quote >

JCM Model Project “Power generation by waste

JCM Model Project “Power generation by waste heat recovery in cement industry” Gen TAKAHASHI Deputy General Manager Global Business Development 3 March 2016 JCM Open Seminar 2 About JFE Engineering Project

lexie@zozen.com > Get A Quote >

Waste Heat Recovery For Desalination From Steam

2014/04/17 · Using heat pumps to condense steam in Steam Power Plants (SPPs) allows the recovery of waste heat at high efficiency. The amount of heat becoming available as useful heat at the discharge of the heat pump amounts to 150

lexie@zozen.com > Get A Quote >

Waste Heat Recovery - US Department of Ener

Indexof Tables Table A Research, Development, and Demonstration Needs for Addressing Waste Heat Recovery Barriers xv Table 4 Temperature Classification of Waste Heat Sources and Related Table 5 General Range Of Heat

lexie@zozen.com > Get A Quote >

Thermoelectric Conversion of Exhaust Gas Waste

1 Thermoelectric Conversion of Exhaust Gas Waste Heat into Usable Electricity Gregory P. Meisner General Motors Global Research & Development 2011 Directions in 2 •Acknowledgements •Introduction •Develop TE Generator

lexie@zozen.com > Get A Quote >

Industrial Waste Heat Recovery System | Echogen

Echogen’s Heat Recovery System is an advanced power generation cycle for usable waste heat recovery. Our engineers have leveraged the proven steam Rankine cycle technology to yield significant improvements in: Performance

lexie@zozen.com > Get A Quote >

MAHLE Waste Heat Recovery - YouTu

2016/12/20 · MAHLE Waste Heat Recovery MAHLE Loading Unsubscribe from MAHLE? Cancel Unsubscribe Working Subscribe Subscribed Unsubscribe 6.8K Loading Loading Working Add to Want to watch this again later?

lexie@zozen.com > Get A Quote >

KAWASAKI WASTE HEAT RECOVERY POWE

Waste Heat Recovery Power Generation (WHRPG) for Cement Plant 22nd November 2007 KAWASAKI PLANT SYSTEMS, LTD. Energy Saving Seminar in Mexico 1 3 PH Boiler Turbine / Generator Building Demineralizer Building

lexie@zozen.com > Get A Quote >

An Overview of Thermoelectric Waste Heat

Thermoelectrics Applications Workshop Del Coronado Hotel San Diego, CA September 29-October 2, 2009 An Overview of Thermoelectric Waste Heat Recovery Activities "Design a thermoelectric generator (TEG) that can be

lexie@zozen.com > Get A Quote >

「waste heat recovery power generation」にした

To provide a solar heat utilizing waste power generation device capable of effectively utilizing waste heat recovery power generation facility capacity of waste power generation facilities, improving power generation efficiency in utilizing solar

lexie@zozen.com > Get A Quote >

Waste Heat Recovery Power Plant - EC

F-24 Keywords E25 Waste Heat Recovery Power Plant u The waste heat recovery power plant recovers heat from the high-temperature exhaust gas discharged from various plants, and generates electric energy. u Many cement

lexie@zozen.com > Get A Quote >