describe steam boiler firetube and watertube

Industrial boilers

Product thermal capacity: 4-35 t/h

Working pressure: 1.0-2.5 MPA

Outlet temperature: 184-350 ℃

Available fuel: natural gas, coke oven gas, bio-gas,liquid propane gas, diesel, heavy oil, light oil, crude oil

Available industries: Petroleum, chemical, chemical fiber, pharmaceutical, textile printing and dyeing, building materials, wood processing, vegetable oil processing and other industries

  • Product introduction
  • Technical advantages

describe steam boiler firetube and watertube have a three-pass round coil structure. A conical coil is used for the effective protection of the furnace wall at the boiler end. This product is equipped with an advanced combustion device and is fully automated in operation. After the burner ignites the fuel, flame fills the round coil tubes and transfers heat by radiation through the tube wall (first pass). The high temperature flue gas gathers at the back door and then turns to the convection tubes section (second pass), where heat transfer takes place by convection. The flue gas gradually cools down here and flows to the front door, where it is reversed and goes into the third pass. After that, it enters into the chimney through the economizer and is released into the atmosphere.

describe steam boiler firetube and watertube.This type of heater is delivered as a whole, and is installed on site, it only needs to connect thermal gas(oil) piping and electricity to start operation. The heater has four heating areas: furnace radiation heating area, the first convection tube bundle heating area, the second convection tube bundle heating area and economizer (waste heat boiler).

Digitized manufacture
  • The laying-off of steel tube adopts CNC 3D laser cutting machine.
  • The manufacture of round coil tube adopts CNC coil tube automatic production line. Once-forming and no need for plastic .
Full argon arc welding
  • The tube butt adopts argon arc welding technique and the seams will be done x ray real-time imaging, preventing unqualified seams from entering coil production line .
Easy operation
  • Heater is wholly assembled before delivery, it is easy for installation, debugging and operating.
  • Fully automatic operating, burning, liquid level of high level tank, outlet temperature and flow rate are adjusted automatically and self-protected.
  • The inlet and outlet with end flanges and flanged cover structure facilitate the installation and layout of tubeline in boiler house.
Less fuel consumption
  • Internal side adopts good insulation material, outside uses stainless steel plate, which can mostly reduce heat lost and make working environment better.
  • Multilayers closely spaced tube bundle and steel rod is used to seal and fix, completely eradicating short circuit of flue gas.
  • Before delivery, the residue moisture is removed completely, so the system draining period is reduced to 2 days from 12 days.
Safely operation
  • The inner coil tube has bigger flow rate, so it is more stable under high temperature operation.
  • Conical coil effectively protects the furnace wall at the end of heater and burner on the top.
describe steam boiler firetube and watertube describe steam boiler firetube and watertube describe steam boiler firetube and watertube

Steam Boilers – R.F. MacDonald C

100HP Mobile Steam Plant; 150HP Mobile Steam Plant; 500HP Mobile Steam Plant; 600HP Mobile Steam Plant; Firetube Steam. 16HP Electric Steam; 130HP Vertical Steam; 250HP Firetube Steam; 400HP Firetube Steam; 600HP Firetube Steam; Watertube Steam. 36,000PPH Watertube Steam; Trailer-Mounted Boiler; Auxiliary Equipment. 30,000PPH Deaerator Tank > Get A Quote >

Boiler Operation & Control - DuPo

Marine boiler; identify the characteristics and uses of a watertube boiler; describe the features and applications of the steam and waterside components of the watertube boiler; describe the features and applications of the fuel layer or fireside of the watertube boiler; and analyze how the components of a watertube boiler function as a whole. > Get A Quote >

Firetube Boilers Flashcards - Cram.c

Same as firetube power boilers except that they operate at a lower pressure with steam heating boilers not exceeding 100 kPa and hot water heating boilers not exceeding 120oC and 1100 kPa. When used in hot water service, a forced circulation pump is usually necessary to … > Get A Quote >

Guide to Low-Emission Boiler and Combustion Equipmen

GUIDE TO LOW-EMISSION BOILER AND COMBUSTION EQUIPMENT SELECTION C. B. Oland Date Published: April 2002 Prepared for the U.S. Department of Energy Office of Industrial Technologies Prepared by OAK RIDGE NATIONAL LABORATORY Oak Ridge, Tennessee 37831 managed by UT-BATTELLE, LLC for the U.S. DEPARTMENT OF ENERGY under contract DE-AC05-00OR22725 > Get A Quote >

What is difference between water tube boiler and fire tub

5/5/2017 · Water Tube Boiler: * Water circulates in tubes and heated externally by hot gases. Fuel is burned inside the furnace. i.e (hot gases- outside the tubes and water- inside the tubes). * Operating pressure = upto 100 bar * Efficiency = upto 90% * Ste > Get A Quote >

Cleaver-Brooks | Reference Center | Resource Librar

Contents 2 The Power of Total Integration 2 Solutions Map 4 High Efficiency 4 Low Emissions 6 Genuine Parts, Upgrades and Maintenance 8 Industrial Watertube Boilers 11 Heat Recovery Steam Generators 12 CBEX Firetube Boilers 17 Flexible Watertube 17 Electric and Electrode Boilers 18 Commercial and Condensing Boilers 20 . Corporate Brochure (Chinese) > Get A Quote >

Boiler|Fundamentals|Basic|and|Operation - YouTu

1/14/2018 · in this video we will describe boiler Fundamentals Basic and Operation and heat transfer basics conduction,convection, radiation basic boiler operation,boile > Get A Quote >

Steam Boiler White Papers — R.F. MacDonald C

White papers on steam boilers and condensing technology. Topics include: steam boilers and how they work, types of steam boilers, what is a steam boiler, condensing technology overviews, steam boiler news and technology, top 10 steam boilers and more. > Get A Quote >

Boiler Types Online Training Cour

Boiler Operation & Control: Boiler Design & Construction is part two of the Boiler Operation & Control five-part training series.. The course teaches students about the different types of boilers. Students will also gain knowledge about the functions of the watertube boiler components, to include the steam and water side of the boiler as well as the fuel and air side. > Get A Quote >

what are steam boilers used for – supply hot water boile

11/27/2018 · Steam Boilers | TurboFuture Nov 4, 2016 A steam boiler generates energy by. These boilers are generally used in industrial applications, because they are oftentimes very large, very Treatment of feed water for steam boilers using magnetic devices – HSE concern is … > Get A Quote >

Water-tube boiler - Wikiped

A high pressure watertube boiler (also spelled water-tube and water tube) is a type of boiler in which water circulates in tubes heated externally by the fire. Fuel is burned inside the furnace, creating hot gas which heats water in the steam-generating tubes.In smaller boilers, additional generating tubes are separate in the furnace, while larger utility boilers rely on the water-filled tubes > Get A Quote >