analysis project over boilers

Industrial boilers

Product thermal capacity: 4-35 t/h

Working pressure: 1.0-2.5 MPA

Outlet temperature: 184-350 ℃

Available fuel: natural gas, coke oven gas, bio-gas,liquid propane gas, diesel, heavy oil, light oil, crude oil

Available industries: Petroleum, chemical, chemical fiber, pharmaceutical, textile printing and dyeing, building materials, wood processing, vegetable oil processing and other industries

  • Product introduction
  • Technical advantages
Introduction

analysis project over boilers have a three-pass round coil structure. A conical coil is used for the effective protection of the furnace wall at the boiler end. This product is equipped with an advanced combustion device and is fully automated in operation. After the burner ignites the fuel, flame fills the round coil tubes and transfers heat by radiation through the tube wall (first pass). The high temperature flue gas gathers at the back door and then turns to the convection tubes section (second pass), where heat transfer takes place by convection. The flue gas gradually cools down here and flows to the front door, where it is reversed and goes into the third pass. After that, it enters into the chimney through the economizer and is released into the atmosphere.


analysis project over boilers.This type of heater is delivered as a whole, and is installed on site, it only needs to connect thermal gas(oil) piping and electricity to start operation. The heater has four heating areas: furnace radiation heating area, the first convection tube bundle heating area, the second convection tube bundle heating area and economizer (waste heat boiler).

Digitized manufacture
  • The laying-off of steel tube adopts CNC 3D laser cutting machine.
  • The manufacture of round coil tube adopts CNC coil tube automatic production line. Once-forming and no need for plastic .
Full argon arc welding
  • The tube butt adopts argon arc welding technique and the seams will be done x ray real-time imaging, preventing unqualified seams from entering coil production line .
Easy operation
  • Heater is wholly assembled before delivery, it is easy for installation, debugging and operating.
  • Fully automatic operating, burning, liquid level of high level tank, outlet temperature and flow rate are adjusted automatically and self-protected.
  • The inlet and outlet with end flanges and flanged cover structure facilitate the installation and layout of tubeline in boiler house.
Less fuel consumption
  • Internal side adopts good insulation material, outside uses stainless steel plate, which can mostly reduce heat lost and make working environment better.
  • Multilayers closely spaced tube bundle and steel rod is used to seal and fix, completely eradicating short circuit of flue gas.
  • Before delivery, the residue moisture is removed completely, so the system draining period is reduced to 2 days from 12 days.
Safely operation
  • The inner coil tube has bigger flow rate, so it is more stable under high temperature operation.
  • Conical coil effectively protects the furnace wall at the end of heater and burner on the top.
analysis project over boilers analysis project over boilers analysis project over boilers

Performance Analysis For Heat Recovery Components In Coal Or

M.Nageswara rao[4] This project mainly deals with design, modeling and fabrication and cfd analysis of a shell and tube air preheater. Over all heat transfer coefficient of the shell and tube heat exchanger is based on the results of effectiveness-ntu approach

lexie@zozen.com > Get A Quote >

Biomass for busines

Our analysis suggests that Bioenergy could account for up to half of the renewable energy required to meet the 2020 renewables target. HOW DO MODERN BIOMASS BOILERS WORK? In the case of wood chip and wood pellet boilers,

lexie@zozen.com > Get A Quote >

Steam/water circulation design - Energiteknik | K

Steam/Water Circulation Design Sebastian Teir, Antto Kulla Helsinki University of Technology Department of Mechanical Engineering Large volume boilers ..3 Shell type boilers

lexie@zozen.com > Get A Quote >

Condensing Boilers--Are They Cost Effectiv

Cost Effectiveness One of the common concerns of HVAC contractors and potential customers is whether the large cost difference between condensing and non-condensing boilers is recouped in energy savings. This question requires an analysis of both the

lexie@zozen.com > Get A Quote >

Energy and economic analysis of industrial boilers | Request P

Request PDF on ResearchGate | Energy and economic analysis of industrial boilers | In this paper, the useful concept of energy and exergy utilization is analyzed, and applied to the boiler system. Energy and exergy flows in a boiler have been shown in this paper.

lexie@zozen.com > Get A Quote >

BOILER TYPES FOR STEAM APPLICATIO

Over the last few years, these basic styles have expanded to include a wide variety of different boilers, and with each new design comes an opportunity for a better match between the …

lexie@zozen.com > Get A Quote >

A Study Analysis and Performance of High Pressure Boilers With

A Study Analysis and Performance of High Pressure Boilers With its Accessories J. Suresh babu1,R.Latha2 3,B.Praveen ,V.Anil kumar4,R Rama kumar5,s.peerulla6 1 Assistant Professor in MED, K.S.R.M College of engineering, AP, India

lexie@zozen.com > Get A Quote >

PROCESS DESIGN OF STEAM BOILERS (PROJECT STANDARDS

KLM Technology Group Project Engineering Standard PROCESS DESIGN OF STEAM BOILERS (PROJECT STANDARDS AND SPECIFICATIONS) Page 2 of 45 Rev: 01 April 2011 Lighting 28 Boiler Feed and Boiler Water Quality and Chemical Conditioning 28

lexie@zozen.com > Get A Quote >

Boiler Inspections - Water and Wastewater Treatment Solutions |

Boilers 123 Boiler Inspections By James McDonald, PE, CWT Originally Published: CSTR October 2005 In each report the waterside conditions, fireside conditions, test analysis, conclusions and recommendations should be covered with pictures and

lexie@zozen.com > Get A Quote >

Updated Buildings Sector Appliance and Equipment Costs and

2 In addition to the Reference case, the demand sectors also project scenarios to explore different assumptions for the cost and performance of future technologies. For the more optimistic cases, some equipment achieves lower life-cycle costs through improved

lexie@zozen.com > Get A Quote >

Biomass Boiler Reduces Natural Gas Consumption at Food

Project Overview Boilers are a critical element of industrial operations in the United States, consuming roughly 20% of the natural gas used in the manu-facturing sector. Within the U.S. manufacturing sector, the food processing industry alone utilizes over

lexie@zozen.com > Get A Quote >