pr oject on boiler efficiency and cooling tower efficiency

Industrial boilers

Product thermal capacity: 4-35 t/h

Working pressure: 1.0-2.5 MPA

Outlet temperature: 184-350 ℃

Available fuel: natural gas, coke oven gas, bio-gas,liquid propane gas, diesel, heavy oil, light oil, crude oil

Available industries: Petroleum, chemical, chemical fiber, pharmaceutical, textile printing and dyeing, building materials, wood processing, vegetable oil processing and other industries

  • Product introduction
  • Technical advantages
Introduction

pr oject on boiler efficiency and cooling tower efficiency have a three-pass round coil structure. A conical coil is used for the effective protection of the furnace wall at the boiler end. This product is equipped with an advanced combustion device and is fully automated in operation. After the burner ignites the fuel, flame fills the round coil tubes and transfers heat by radiation through the tube wall (first pass). The high temperature flue gas gathers at the back door and then turns to the convection tubes section (second pass), where heat transfer takes place by convection. The flue gas gradually cools down here and flows to the front door, where it is reversed and goes into the third pass. After that, it enters into the chimney through the economizer and is released into the atmosphere.


pr oject on boiler efficiency and cooling tower efficiency.This type of heater is delivered as a whole, and is installed on site, it only needs to connect thermal gas(oil) piping and electricity to start operation. The heater has four heating areas: furnace radiation heating area, the first convection tube bundle heating area, the second convection tube bundle heating area and economizer (waste heat boiler).

Digitized manufacture
  • The laying-off of steel tube adopts CNC 3D laser cutting machine.
  • The manufacture of round coil tube adopts CNC coil tube automatic production line. Once-forming and no need for plastic .
Full argon arc welding
  • The tube butt adopts argon arc welding technique and the seams will be done x ray real-time imaging, preventing unqualified seams from entering coil production line .
Easy operation
  • Heater is wholly assembled before delivery, it is easy for installation, debugging and operating.
  • Fully automatic operating, burning, liquid level of high level tank, outlet temperature and flow rate are adjusted automatically and self-protected.
  • The inlet and outlet with end flanges and flanged cover structure facilitate the installation and layout of tubeline in boiler house.
Less fuel consumption
  • Internal side adopts good insulation material, outside uses stainless steel plate, which can mostly reduce heat lost and make working environment better.
  • Multilayers closely spaced tube bundle and steel rod is used to seal and fix, completely eradicating short circuit of flue gas.
  • Before delivery, the residue moisture is removed completely, so the system draining period is reduced to 2 days from 12 days.
Safely operation
  • The inner coil tube has bigger flow rate, so it is more stable under high temperature operation.
  • Conical coil effectively protects the furnace wall at the end of heater and burner on the top.
pr oject on boiler efficiency and cooling tower efficiency pr oject on boiler efficiency and cooling tower efficiency pr oject on boiler efficiency and cooling tower efficiency

Boilers | Products - Energy St

Earning the ENERGY STAR means products meet strict energy efficiency guidelines set by the U.S. Environmental Protection Agency. By choosing ENERGY STAR certified heating and cooling equipment and taking steps to

lexie@zozen.com > Get A Quote >

Oregon Institute of Technology Organic Rankine

water cooling tower. The ORC cycle is used to convert low temperature heat to electricity. This was the first geothermal CHP project at a college campus in the world. Reasons for CHP The success of the initial CHP system led

lexie@zozen.com > Get A Quote >

Discover the world's resear

The system of separate production of heat energy from a boiler and cooling energy from a compression refrigeration unit powered with …

lexie@zozen.com > Get A Quote >

(PDF) Heat Pump Market in Thailand - ResearchGate |

Ground sou rce heat pumps are water-loop system where the boiler and cooling tower have been replaced with a buried earth heat exchanger. Heat is absorbed from or rejected to the ground, and the external energy needed to

lexie@zozen.com > Get A Quote >

Active Control Technologies for VRF Heat Pump Cyc

5 Innovative Technologies for Multi V IV Introduction Multi V IV has innovative active control technologies for VRF heat pump cycle. LG Scroll Comp. HiPOR Active Oil Control Active Ref. Control Active Var. HEX Higher Efficiency

lexie@zozen.com > Get A Quote >

"Improving the Boiler Efficiency by Optimizing the

The APHX inlet temperature will have an indirect effect on the primary burner efficiency that was not captured in these results. Based on published curves [15, 16] showing boiler efficiency gain versus reduction in flue gas temperature

lexie@zozen.com > Get A Quote >

IJEET - Performance Analysis from the Energy Audit Of

Performance Analysis from the Energy Audit Of A Thermal Power Plant Skip to content Jump to main navigation and login Nav view search Navigation Home Call for Paper

lexie@zozen.com > Get A Quote >

Energy use project and conversion efficiency

Energy use project and conversion efficiency analysis on biogas produced in breweries LI Yingjian 1,*, QIU Qi 1, HE Xiangzhu 2, LI Jiezhi 3 1 College of Chemistry & Chemical Engineering, Shenzhen University, 518060, Shenzhen

lexie@zozen.com > Get A Quote >

Why is the thermal efficiency of steam power plant low?

Heat Addition (Boiler) Efficiency of boiler can be increased by using Pulverized fuel = Proper combustion Re-heater, Econ-miser and Air Preheater = Heat Utilization More Heat Transfer Area Better Material Better Fuel with less

lexie@zozen.com > Get A Quote >

How do cooling towers work? - Quo

Why Do I Need Water Treatment Chemical water treatment for cooling towers, as well as up-to-date equipment, is essential in order to keep cooling towers operating at high efficiency and also to prevent risk of damage. Water that is

lexie@zozen.com > Get A Quote >

Steam and Water Analysis Systems (SWAS) - Forbes

Steam and Water Analysis Systems (SWAS) Sample Conditioning The first section of any SWAS is the sample conditioning section or the wet panel. Open Frame-Free Standing Wet Rack Here the sample is first cooled in

lexie@zozen.com > Get A Quote >