waste heat boiler in sulfur recovery unit

Industrial boilers

Product thermal capacity: 4-35 t/h

Working pressure: 1.0-2.5 MPA

Outlet temperature: 184-350 ℃

Available fuel: natural gas, coke oven gas, bio-gas,liquid propane gas, diesel, heavy oil, light oil, crude oil

Available industries: Petroleum, chemical, chemical fiber, pharmaceutical, textile printing and dyeing, building materials, wood processing, vegetable oil processing and other industries

  • Product introduction
  • Technical advantages
Introduction

waste heat boiler in sulfur recovery unit have a three-pass round coil structure. A conical coil is used for the effective protection of the furnace wall at the boiler end. This product is equipped with an advanced combustion device and is fully automated in operation. After the burner ignites the fuel, flame fills the round coil tubes and transfers heat by radiation through the tube wall (first pass). The high temperature flue gas gathers at the back door and then turns to the convection tubes section (second pass), where heat transfer takes place by convection. The flue gas gradually cools down here and flows to the front door, where it is reversed and goes into the third pass. After that, it enters into the chimney through the economizer and is released into the atmosphere.


waste heat boiler in sulfur recovery unit.This type of heater is delivered as a whole, and is installed on site, it only needs to connect thermal gas(oil) piping and electricity to start operation. The heater has four heating areas: furnace radiation heating area, the first convection tube bundle heating area, the second convection tube bundle heating area and economizer (waste heat boiler).

Digitized manufacture
  • The laying-off of steel tube adopts CNC 3D laser cutting machine.
  • The manufacture of round coil tube adopts CNC coil tube automatic production line. Once-forming and no need for plastic .
Full argon arc welding
  • The tube butt adopts argon arc welding technique and the seams will be done x ray real-time imaging, preventing unqualified seams from entering coil production line .
Easy operation
  • Heater is wholly assembled before delivery, it is easy for installation, debugging and operating.
  • Fully automatic operating, burning, liquid level of high level tank, outlet temperature and flow rate are adjusted automatically and self-protected.
  • The inlet and outlet with end flanges and flanged cover structure facilitate the installation and layout of tubeline in boiler house.
Less fuel consumption
  • Internal side adopts good insulation material, outside uses stainless steel plate, which can mostly reduce heat lost and make working environment better.
  • Multilayers closely spaced tube bundle and steel rod is used to seal and fix, completely eradicating short circuit of flue gas.
  • Before delivery, the residue moisture is removed completely, so the system draining period is reduced to 2 days from 12 days.
Safely operation
  • The inner coil tube has bigger flow rate, so it is more stable under high temperature operation.
  • Conical coil effectively protects the furnace wall at the end of heater and burner on the top.
waste heat boiler in sulfur recovery unit waste heat boiler in sulfur recovery unit waste heat boiler in sulfur recovery unit

Sulfur Recovery Unit Apply For Petrol-chemical And

Sulfur Recovery Unit is used for pollution abatement, including heat reactor furnace, burners, catalyzing reactor, waste heat boiler and sulfur condenser. Heat Reactor Furnace As the main equipment in the sulfur recovery unit, the

lexie@zozen.com > Get A Quote >

AP-42, CH 8.13: Sulfur Recovery - United State

achieved depending on the number of catalytic reaction stages and the type of reheating method used. Figure 8.13-1. Typical Claus sulfur recovery unit. CW = Cooling water. STM = Steam. BFW = Boiler feed water. If the sulfur

lexie@zozen.com > Get A Quote >

Why do waste heat boilers fail? - Home - Porter

SRU WASTE HEAT BOILER FAILURES 2 www.sulphurmagazine.com Sulphur 354 | September - October 2014 out adequate tempering can significantly impact the reliability of the refractory and ferrule systems. Temperatures in

lexie@zozen.com > Get A Quote >

Sulfur Recovery from Acid Gas Using the Claus

passed into the Claus unit for sulfur recovery. The process is also known as Gas sweetening and Acid gas removal. 1Amines are also used in many oil refineries to

lexie@zozen.com > Get A Quote >

Waste heat boiler for sulfur recovery un

Typical application : Offgas waste heat boiler for sulfur recovery unit expansion project, CNPC Lanzhou Company An offgas waste heat boiler was provided for the sulfur recovery unit expansion project built by CNPC Lanzhou

lexie@zozen.com > Get A Quote >

Design of SRU Thermal Reactor and Waste Heat Boile

Design of SRU Thermal Reactor and Waste Heat Boiler Considering Recombination Reactions Article (PDF Available) in Procedia Engineering 42:376–383 · December 2012 with 2,608 Reads

lexie@zozen.com > Get A Quote >

Steady State Simulation of Reaction Furnace and Wast

عنوان مقاله: Steady State Simulation of Reaction Furnace and Waste Heat Boiler of Sulfur Recovery Unit of Ilam Refinery Using Aspen® software شناسه (COI) مقاله: NICEC16_415 منتشر شده در شانزدهمین کنگره ملی مهندسی شیمی ایران در سال ۱۳۹۷

lexie@zozen.com > Get A Quote >

Sulfur Recovery Units - BORN In

The 3-Tier Sulphur Recovery Unit conceptualized and designed by BORN recently, exemplifies BORN’s continuing leadership in innovations when it comes to meeting client’s requirements without compromising on process

lexie@zozen.com > Get A Quote >

Reaction Furnace And Waste Heat Boil

Design of Heat Recovery Equipments in Sulfur Recovery Unit Waste Heat Boiler Waste heat boiler is installed just after the reactor furnace. High-pressure steam (usually up to 45 kg/cm2-g) is generated by cooling the combusted gas

lexie@zozen.com > Get A Quote >

Case Studies of Waste Heat Boiler Failure in Refinerie

refractory, sulfidic corrosion, flexi-coking unit, overheating, waste heat boiler, ferrule, sulfur recovery unit, hydrogen plant, molten salts Downloads 2 in the last 30 days 278 since 2007 Show more detail Price: USD 20.00

lexie@zozen.com > Get A Quote >

claus waste heat boiler – Biomass Fired Boil

Jan, 25, 2018 Jenny Wu Application No Comments. The first section of sulphur recovery units (SRU) based on Claus process is constituted of a burner, a thermal reactor and a waste heat boiler and it is designed to oxidize acid

lexie@zozen.com > Get A Quote >