normal pressure hot water boiler

Industrial boilers

Product thermal capacity: 4-35 t/h

Working pressure: 1.0-2.5 MPA

Outlet temperature: 184-350 ℃

Available fuel: natural gas, coke oven gas, bio-gas,liquid propane gas, diesel, heavy oil, light oil, crude oil

Available industries: Petroleum, chemical, chemical fiber, pharmaceutical, textile printing and dyeing, building materials, wood processing, vegetable oil processing and other industries

  • Product introduction
  • Technical advantages
Introduction

normal pressure hot water boiler have a three-pass round coil structure. A conical coil is used for the effective protection of the furnace wall at the boiler end. This product is equipped with an advanced combustion device and is fully automated in operation. After the burner ignites the fuel, flame fills the round coil tubes and transfers heat by radiation through the tube wall (first pass). The high temperature flue gas gathers at the back door and then turns to the convection tubes section (second pass), where heat transfer takes place by convection. The flue gas gradually cools down here and flows to the front door, where it is reversed and goes into the third pass. After that, it enters into the chimney through the economizer and is released into the atmosphere.


normal pressure hot water boiler.This type of heater is delivered as a whole, and is installed on site, it only needs to connect thermal gas(oil) piping and electricity to start operation. The heater has four heating areas: furnace radiation heating area, the first convection tube bundle heating area, the second convection tube bundle heating area and economizer (waste heat boiler).

Digitized manufacture
  • The laying-off of steel tube adopts CNC 3D laser cutting machine.
  • The manufacture of round coil tube adopts CNC coil tube automatic production line. Once-forming and no need for plastic .
Full argon arc welding
  • The tube butt adopts argon arc welding technique and the seams will be done x ray real-time imaging, preventing unqualified seams from entering coil production line .
Easy operation
  • Heater is wholly assembled before delivery, it is easy for installation, debugging and operating.
  • Fully automatic operating, burning, liquid level of high level tank, outlet temperature and flow rate are adjusted automatically and self-protected.
  • The inlet and outlet with end flanges and flanged cover structure facilitate the installation and layout of tubeline in boiler house.
Less fuel consumption
  • Internal side adopts good insulation material, outside uses stainless steel plate, which can mostly reduce heat lost and make working environment better.
  • Multilayers closely spaced tube bundle and steel rod is used to seal and fix, completely eradicating short circuit of flue gas.
  • Before delivery, the residue moisture is removed completely, so the system draining period is reduced to 2 days from 12 days.
Safely operation
  • The inner coil tube has bigger flow rate, so it is more stable under high temperature operation.
  • Conical coil effectively protects the furnace wall at the end of heater and burner on the top.
normal pressure hot water boiler normal pressure hot water boiler normal pressure hot water boiler

industry hot water normal pressure fire tube boile

hot water. The mainstay technology for generating heating or process energy is the packaged firetube boiler has proven to be highly efficient support through our “best in the industry” high pressure drop design, and simple, robust.

lexie@zozen.com > Get A Quote >

water pressure in boiler - degrensvoorbij.

The Normal PSI Reading for a Hot Water Boiler System | Hunker. The pressure gauge on most hot water boiler systems is located on the front of the unit, sometimes near the top. This gauge shows the current internal pressure and temperature inside the boiler. .

lexie@zozen.com > Get A Quote >

school fuel hot water normal pressure boil

The reader is cautioned to refer to the latest edition of the ASME Boiler and Pressure Vessel Code for current requirements. View More; Pressure Cooker Opening Methods Explained + Tips! ⋆ hip. 2014-12-14 · Cold-water Quick Fastest Move stove top pressure cooker to sink and pour cold water on the lid.

lexie@zozen.com > Get A Quote >

What is the safe pressure for a hot-water-heating syste

1/19/2015 · Most residential hot water heating systems run at 5-psi more than the pressure required to raise the water from the fill valve to the highest point in the system. In my Cape Cod house, with the boiler on the floor of my garage, the pressure gauge reads between 12- and 15-psi (the dial is too small to read more accurately than that).

lexie@zozen.com > Get A Quote >

Bath Fuel Hot Water Normal Pressure Boil

Bath Fuel Hot Water Normal Pressure Boiler. Hot Water Heating Boiler failure due to non functioning low water cutout This was a domestic or residential size hot water heating boiler used for building heat. This was a Federal Facility located in Maine in which the State of Maine has no jurisdiction.

lexie@zozen.com > Get A Quote >

Locomotive Hot Water Normal Pressure Water Tube Boil

Locomotive Hot Water Normal Pressure Water Tube Boiler. Boiler: April 2011 - heatboilers.blogspot.com. Water tube boiler products, buy water tube boiler products from a water tube boiler is a type of boiler in which water circulates in tubes heated externally by the …

lexie@zozen.com > Get A Quote >

The Normal PSI Reading for a Hot Water Boiler System | Hunk

The standard cold water operating pressure of most U.S. and Canadian hot water boilers is 12 pounds per square inch (psi). If the boiler pressure drops below 12 psi, the valve will allow new water into the unit to bring up the pressure reading.

lexie@zozen.com > Get A Quote >

Low hot water pressure from combi boiler - advice pleas

7/30/2008 · Low hot water pressure from combi boiler - advice please. If it is a problem external to the boiler on the hot water side is going to be in a very short length of pipe because it tee's off to supply upstairs bathroom and downstairs kitchen 1.5 meters after leaving boiler, and there is poor hot water pressure everywhere.

lexie@zozen.com > Get A Quote >

Horizontal normal pressure hot water boiler | Textil

Horizontal normal pressure hot water boiler. Quick inquiry: I need the quotation of , the fuel is , the pressure is , this capacity is , My Name is , my Email is , my phone number is , Please Send the detail information for me! Feed Water Pressure Regulators – Watts Water … Feed Water Pressure Regulators Series 1450F, T-1450F, S-1450F and

lexie@zozen.com > Get A Quote >

supermarket fuel hot water normal pressure boil

Boiler name : supermarket fuel hot water normal pressure boiler Boiler Distributor :Elegant design with low surface temperature and low heat dissipation Available fuel : Nature gas, coke oven gas, biogas, methanol, etc. E-mail : [email protected] Please email or call us for your inquiry

lexie@zozen.com > Get A Quote >

What to do if your boiler loses pressure - British G

If you’re having problems with your boiler — like the dreaded 'no hot water' — loss of water pressure might be to blame. The good news is that low pressure is relatively easy to diagnose and, in some cases, you can put it right yourself.

lexie@zozen.com > Get A Quote >