fluidized bed combustion

Industrial boilers

Product thermal capacity: 4-35 t/h

Working pressure: 1.0-2.5 MPA

Outlet temperature: 184-350 ℃

Available fuel: natural gas, coke oven gas, bio-gas,liquid propane gas, diesel, heavy oil, light oil, crude oil

Available industries: Petroleum, chemical, chemical fiber, pharmaceutical, textile printing and dyeing, building materials, wood processing, vegetable oil processing and other industries

  • Product introduction
  • Technical advantages
Introduction

fluidized bed combustion have a three-pass round coil structure. A conical coil is used for the effective protection of the furnace wall at the boiler end. This product is equipped with an advanced combustion device and is fully automated in operation. After the burner ignites the fuel, flame fills the round coil tubes and transfers heat by radiation through the tube wall (first pass). The high temperature flue gas gathers at the back door and then turns to the convection tubes section (second pass), where heat transfer takes place by convection. The flue gas gradually cools down here and flows to the front door, where it is reversed and goes into the third pass. After that, it enters into the chimney through the economizer and is released into the atmosphere.


fluidized bed combustion.This type of heater is delivered as a whole, and is installed on site, it only needs to connect thermal gas(oil) piping and electricity to start operation. The heater has four heating areas: furnace radiation heating area, the first convection tube bundle heating area, the second convection tube bundle heating area and economizer (waste heat boiler).

Digitized manufacture
  • The laying-off of steel tube adopts CNC 3D laser cutting machine.
  • The manufacture of round coil tube adopts CNC coil tube automatic production line. Once-forming and no need for plastic .
Full argon arc welding
  • The tube butt adopts argon arc welding technique and the seams will be done x ray real-time imaging, preventing unqualified seams from entering coil production line .
Easy operation
  • Heater is wholly assembled before delivery, it is easy for installation, debugging and operating.
  • Fully automatic operating, burning, liquid level of high level tank, outlet temperature and flow rate are adjusted automatically and self-protected.
  • The inlet and outlet with end flanges and flanged cover structure facilitate the installation and layout of tubeline in boiler house.
Less fuel consumption
  • Internal side adopts good insulation material, outside uses stainless steel plate, which can mostly reduce heat lost and make working environment better.
  • Multilayers closely spaced tube bundle and steel rod is used to seal and fix, completely eradicating short circuit of flue gas.
  • Before delivery, the residue moisture is removed completely, so the system draining period is reduced to 2 days from 12 days.
Safely operation
  • The inner coil tube has bigger flow rate, so it is more stable under high temperature operation.
  • Conical coil effectively protects the furnace wall at the end of heater and burner on the top.
fluidized bed combustion fluidized bed combustion fluidized bed combustion

FLUIDIZED COMBUSTION - Politechnika Wrocławs

Fluidized bed-combustion features a) direct contact of particles withintensivemass and heat exchange, b) uniform temperature in the fluidized bed c) high heat capacity of fluidized bed makingitpossible to burn fuels of low quality, wet and with high content of ash

lexie@zozen.com > Get A Quote >

Circulating Fluidized Bed Boiler | CFB Boiler | GE Pow

Ultra-Supercritical Circulating Fluidized Bed (CFB) Boilers. 660 MWe for lignite B, higher for hard coal, for low-grade and difficult-to-burn fuels such as anthracite, lignite, petroleum coke, oil shale, discarded coal and biomass, GE offer circulating fluidized bed technologies with different arrangements suited to fuel .

lexie@zozen.com > Get A Quote >

DEVELOPMENT OF FLUIDIZED BED COMBUSTI

combustion of oil shale in Sweden and South Africa. L.Plass, G Daradimos, H Beisswenger, Deveopment of the circulating athmospheric fluidized bed to an environment –conservong combustion technology, VGB Kraftwerkstechnologie 67(5), 399-405 (1987).

lexie@zozen.com > Get A Quote >

Circulating fluidized bed combustion for biomass boil

Efficiency of the CFB Combustion Process. Fluidized-bed boilers are the most common type of boiler recommended for biomass fuel, which is burned within a hot bed of inert particles, typically sand. The fuel-particle mix is suspended by an upward flow of combustion air within the bed.

lexie@zozen.com > Get A Quote >

FLUIDIZED BED COMBUSTION - electrical power generati

FLUIDIZED BED COMBUSTION. While the pulverized coal-fired boiler represents the most efficient type of coal- fired power plant, there are alternatives. One of these is the fluidized bed boiler. This type of combustion system is capable of burning a much wider range of fuels than a PC plant.

lexie@zozen.com > Get A Quote >

Fluidized-bed combustion | Article about fluidized-be

fluidized-bed combustion[¦flü·ə‚dīzd ¦bed kəm′bəs·chən] (mechanical engineering) A method of burning particulate fuel, such as coal, in which the amount of air required for combustion far exceeds that found in conventional burners; the fuel particles are continually fed into a bed of mineral ash in the proportions of 1 part fuel to 200

lexie@zozen.com > Get A Quote >

Hankin Fluidized Bed Incinerator - Engineering and Proces

Hankin Fluidized Bed Incinerator. Hankin is a leader in fluidized bed combustion of sludges generated from municipal and industrial wastewater treatment processes. The Hankin Fluidized Bed Incinerator (FBI) accepts any proportion of sludge, hazardous liquids, grease or scum.

lexie@zozen.com > Get A Quote >

Fluidized bed combustion - COALsp

FLUIDIZED BED COMBUSTION Fluidized bed combustion (FBC) is a combustion technology used in power plants. FBC plants are more flexible than conventional plants in that they can be fired on coal and biomass, among other fuels.

lexie@zozen.com > Get A Quote >

fluidized bed - German translation – Lingu

The high Order Backlog at the end of 2004, and Sales contributions from NETZSCH Filtration and the fluidized bed drying systems Business Area of VA TECH WABAG, which were not included in the financial figures of last year's reference Quarter, were the main reasons for this positive development.

lexie@zozen.com > Get A Quote >

Circulating fluidized bed combustion technology | Ge

The bed agglomeration can be controlled by peeping the bed alkali contents low enough by regularly discharging the bed ash and feeding fresh sand into the bed. The chemistry of fuel ash – bed sand interactions is however complicated. It is usually useful to minimize the quartz contents in the make-up sand. The ash melting […]

lexie@zozen.com > Get A Quote >

Fluidized bed combustion | Revol

Fluidized bed combustion FBC smoke tube boiler Fluidized bed combustion (FBC) is a combustion technology used to burn solid fuels. In its most basic form, fuel particles are suspended in a hot, bubbling fluidity bed of ash and other particulate materials (sand, limestone etc.) through which jets of air are blown to provide the oxygen required for combustion or gasification.

lexie@zozen.com > Get A Quote >