hot water heater 10 years old

Industrial boilers

Product thermal capacity: 4-35 t/h

Working pressure: 1.0-2.5 MPA

Outlet temperature: 184-350 ℃

Available fuel: natural gas, coke oven gas, bio-gas,liquid propane gas, diesel, heavy oil, light oil, crude oil

Available industries: Petroleum, chemical, chemical fiber, pharmaceutical, textile printing and dyeing, building materials, wood processing, vegetable oil processing and other industries

  • Product introduction
  • Technical advantages
Introduction

hot water heater 10 years old have a three-pass round coil structure. A conical coil is used for the effective protection of the furnace wall at the boiler end. This product is equipped with an advanced combustion device and is fully automated in operation. After the burner ignites the fuel, flame fills the round coil tubes and transfers heat by radiation through the tube wall (first pass). The high temperature flue gas gathers at the back door and then turns to the convection tubes section (second pass), where heat transfer takes place by convection. The flue gas gradually cools down here and flows to the front door, where it is reversed and goes into the third pass. After that, it enters into the chimney through the economizer and is released into the atmosphere.


hot water heater 10 years old.This type of heater is delivered as a whole, and is installed on site, it only needs to connect thermal gas(oil) piping and electricity to start operation. The heater has four heating areas: furnace radiation heating area, the first convection tube bundle heating area, the second convection tube bundle heating area and economizer (waste heat boiler).

Digitized manufacture
  • The laying-off of steel tube adopts CNC 3D laser cutting machine.
  • The manufacture of round coil tube adopts CNC coil tube automatic production line. Once-forming and no need for plastic .
Full argon arc welding
  • The tube butt adopts argon arc welding technique and the seams will be done x ray real-time imaging, preventing unqualified seams from entering coil production line .
Easy operation
  • Heater is wholly assembled before delivery, it is easy for installation, debugging and operating.
  • Fully automatic operating, burning, liquid level of high level tank, outlet temperature and flow rate are adjusted automatically and self-protected.
  • The inlet and outlet with end flanges and flanged cover structure facilitate the installation and layout of tubeline in boiler house.
Less fuel consumption
  • Internal side adopts good insulation material, outside uses stainless steel plate, which can mostly reduce heat lost and make working environment better.
  • Multilayers closely spaced tube bundle and steel rod is used to seal and fix, completely eradicating short circuit of flue gas.
  • Before delivery, the residue moisture is removed completely, so the system draining period is reduced to 2 days from 12 days.
Safely operation
  • The inner coil tube has bigger flow rate, so it is more stable under high temperature operation.
  • Conical coil effectively protects the furnace wall at the end of heater and burner on the top.
hot water heater 10 years old hot water heater 10 years old hot water heater 10 years old

My electric home hot water heater is about 10 years ol

My electric home hot water heater is about 10 years old. It's never been drained or had any other maintenance. What do I - Answered by a verified Plumber

lexie@zozen.com > Get A Quote >

My water heater is 10 years old, but it is still workin

2/21/2017 · My water heater is 10 years old, but it is still working fine no problems? Ive had it flushed due to sediment build up, but otherwise no problems. It will probably start making noises soon when your washer draws hot water. Go out and buy a replacement before the prices go up. Your water heater will break down 2.1 years from now

lexie@zozen.com > Get A Quote >

Consider Your Hot Water Heating Options - riversinc.c

12/4/2014 · Hot water options If your water heater is more than 10 years old and has not been maintained, it may be approaching the end of its useful life. If it’s leaking or showing signs of rust, it definitely needs to be replaced. … Continued

lexie@zozen.com > Get A Quote >

Bradford White Water Heater | eB

The Bradford White RG240T6N is a 40 gallon, tall, hot water heater. Is your hot water heater is more than 10 years old?. The lifespan of a conventional storage hot water heater is between 10 and 15 ye

lexie@zozen.com > Get A Quote >

Should I Repair or Replace My Tank Water Heate

12/19/2018 · So if your water heater is 10+ years old, it’s nearing the end of its natural life—especially if it hasn’t been well-maintained. Since it’s only a matter of time before you’ll need to replace your old one, if you’re facing an expensive repair, you should consider replacing your water heater altogether.

lexie@zozen.com > Get A Quote >

How Long Does a Water Heater Last? Cost to Replac

8/5/2018 · In general, unless the unit is more than 10 years old or is leaking from the tank, you can probably fix the one you have. How Much Does it Cost to Install a Water Heater? The cost to install a tank-type gas or electric water heater varies quite a bit. The main factor is …

lexie@zozen.com > Get A Quote >

I have an 11 year old whirlpool water heater, pilot ligh

Whirlpool hot water heater pilot light lit, but burner not igniting. The pilot light on my water heater is lit but the burner does not light. pilot stays lit on Whirlpool gas water heater but burner will not light, less than 2 years old, light flashes 4x

lexie@zozen.com > Get A Quote >

Hot Water Heater Repair or Replacement | Paschall Plumbi

Paschall Hot Water Heater Repair or Replacement Reno NV | Sparks NV. CLICK-2-DIAL(775)825-6500. No one wants to take a cold shower. If your gas water heater is over 10 years old, or is showing signs of leaking, it’s probably best to skip the troubleshooting and just invest in a replacement.

lexie@zozen.com > Get A Quote >

Hot water heater burner keeps going out.? | Yahoo Answe

11/4/2011 · I have a GE Smart Shield gas hot water heater (about 7 years old). Last night we noticed the hot water was out, so i checked the hot water heater and noticed the pilot was out. I re-lit the pilot as i have done a few times before, holding the button down for 1 minute, releasing it and waiting a minute or so before turning the knob to the ";on" position.

lexie@zozen.com > Get A Quote >

Hot water issue | This Old Hou

Help!! I have a gas hot water heater that is approx 10 years old. All the faucets in the house become clogged with a white, chunky "porcelain" looking material that crumbles between my fingers. It is only on the hot water side of the faucets. Once a week I have to take apart each faucet to clean otherwise hot water flow is extremely restricted.

lexie@zozen.com > Get A Quote >

Reasons Why a Water Heater Doesn't Make Enough Hot Wat

The average lifespan of a water heater is 8 to 12 years, and no matter how well you maintain it, eventually sediment will build up, affecting the efficiency of the appliance and reducing the available volume for hot water. If your water heater is at least 10 years old, efforts to …

lexie@zozen.com > Get A Quote >