megawatts of boiler 12 tonnes capacity

Industrial boilers

Product thermal capacity: 4-35 t/h

Working pressure: 1.0-2.5 MPA

Outlet temperature: 184-350 ℃

Available fuel: natural gas, coke oven gas, bio-gas,liquid propane gas, diesel, heavy oil, light oil, crude oil

Available industries: Petroleum, chemical, chemical fiber, pharmaceutical, textile printing and dyeing, building materials, wood processing, vegetable oil processing and other industries

  • Product introduction
  • Technical advantages

megawatts of boiler 12 tonnes capacity have a three-pass round coil structure. A conical coil is used for the effective protection of the furnace wall at the boiler end. This product is equipped with an advanced combustion device and is fully automated in operation. After the burner ignites the fuel, flame fills the round coil tubes and transfers heat by radiation through the tube wall (first pass). The high temperature flue gas gathers at the back door and then turns to the convection tubes section (second pass), where heat transfer takes place by convection. The flue gas gradually cools down here and flows to the front door, where it is reversed and goes into the third pass. After that, it enters into the chimney through the economizer and is released into the atmosphere.

megawatts of boiler 12 tonnes capacity.This type of heater is delivered as a whole, and is installed on site, it only needs to connect thermal gas(oil) piping and electricity to start operation. The heater has four heating areas: furnace radiation heating area, the first convection tube bundle heating area, the second convection tube bundle heating area and economizer (waste heat boiler).

Digitized manufacture
  • The laying-off of steel tube adopts CNC 3D laser cutting machine.
  • The manufacture of round coil tube adopts CNC coil tube automatic production line. Once-forming and no need for plastic .
Full argon arc welding
  • The tube butt adopts argon arc welding technique and the seams will be done x ray real-time imaging, preventing unqualified seams from entering coil production line .
Easy operation
  • Heater is wholly assembled before delivery, it is easy for installation, debugging and operating.
  • Fully automatic operating, burning, liquid level of high level tank, outlet temperature and flow rate are adjusted automatically and self-protected.
  • The inlet and outlet with end flanges and flanged cover structure facilitate the installation and layout of tubeline in boiler house.
Less fuel consumption
  • Internal side adopts good insulation material, outside uses stainless steel plate, which can mostly reduce heat lost and make working environment better.
  • Multilayers closely spaced tube bundle and steel rod is used to seal and fix, completely eradicating short circuit of flue gas.
  • Before delivery, the residue moisture is removed completely, so the system draining period is reduced to 2 days from 12 days.
Safely operation
  • The inner coil tube has bigger flow rate, so it is more stable under high temperature operation.
  • Conical coil effectively protects the furnace wall at the end of heater and burner on the top.
megawatts of boiler 12 tonnes capacity megawatts of boiler 12 tonnes capacity megawatts of boiler 12 tonnes capacity

High-performance steam boiler and hot water boiler plant

steam. In Workington, 200,000 tonnes of chromo cardboard are produced each year. Up to 115 tonnes of steam per hour The two Vitomax D HS double flame tube boilers deliver up to 115 tonnes of steam per hour. The burner output of each flame tube is approximately 19 megawatts, so complete output at full capacity is 38 megawatts. > Get A Quote >

How much steam is required to generate 1MW of electricit

9/7/2016 · While I would certainly suggest learning the formulas & principles relative to the subject (efficiency rate, kWh, etc.), there is a quick and dirty way to determine the amount of steam being used to generate 1 MW/hr of electricity when you’re actu > Get A Quote >


where the calorific power used is more than 20 megawatts, (g) Applying protective fused metal coatings with an input of more than 2 tonnes of crude steel per hour, (h) Casting ferrous metal at a foundry with a production capacity of more than 20 tonnes per day. PART B (2) OJ L 365, 31.12.94, p.24. (3) OJ L 285, 31.10.2009, p.36. 3 > Get A Quote >

Licence -

capacity Approved premises production or design capacity 12 Screening, etc. of material 50 000 tonnes or more per year 1.2 million tonnes of coal per annual period 52 Electric power generation 20 megawatts or more in aggregate (using natural gas) 10 megawatts or more in aggregate (using a fuel other than natural gas) 340 MWe per annual period > Get A Quote >

Steam Calculators: Boiler Calculat

Steam, Boiler, and Blowdown Pressure are the same. Combustion Efficiency is the % of fuel energy that is directly added to the feedwater and not otherwise lost or used. Blowdown Rate is the % of incoming feedwater mass flow rate that leaves the boiler as a saturated liquid at boiler pressure. > Get A Quote >

Bayswater Power Station - Wikiped

Bayswater Power Station is a bituminous (black) coal-powered thermal power station with four 660 megawatts (890,000 hp) Tokyo Shibaura Electric (Japan) steam driven turbo alternators for a combined capacity of 2,640 megawatts (3,540,000 hp). Commissioned between 1985 and 1986, the station is located 16 kilometres (10 mi) from Muswellbrook, and 28 km (17 mi) from Singleton in the Hunter … > Get A Quote >


The process heat (steam) from the electrode boiler will be used to pasteurise milk, sterilise milk, clean production lines and help form product packaging, among other uses. The electrode boiler capacity will initially be 6 megawatts (MW). Synlait has the ability to increase this capacity to 12 megawatts. > Get A Quote >

biomas boilers – Steam Boiler In Ind

Its name comes from the nearby village of Drax.It is situated on the River Ouse between Selby and Goole.Its generating capacity of 3,906 megawatts (MW) is the highest of any power station in the …lecho fluido – Traducción al inglés – Linguee(open/closed, continuous/batchwise), duration and frequency of processing, maximum capacity per > Get A Quote >

Electricity Run Boiler Of Mt Steam Hr Capaci

Johor. The 13,600 kg steam/ hr capacity of water-tube typed boiler used in palm oil mill plant processes800 million tonnes per day of fresh fruit bunch (FFB). The fiber and shell are fed into the boiler with the ratio of 85 % to 15 %. The studied mill is equipped with two boilers and multi-dust cyclone as Air Pollution Control (APC). > Get A Quote >

Steam Capacity Conversion Table | Industrial Contro

Often it is necessary to convert a measure of capacity from one term to another. The conversion table will allow you to quickly convert various measures of capacity. The table and formulas can help you size and pick out components such as condensate pumps and boiler feed pumps. Some additional conversion factors that may prove helpful are shown below. > Get A Quote >

Upgrading and efficiency improvement in coal-fired powe

include restricted resources, lack of skills, pressure to keep online because of power capacity shortages, and, in some cases, having to burn particularly difficult coals. These factors can mean that boiler-related improvements are usually needed as well as turbine works. Where coal quality is > Get A Quote >