high presure boiler

Industrial boilers

Product thermal capacity: 4-35 t/h

Working pressure: 1.0-2.5 MPA

Outlet temperature: 184-350 ℃

Available fuel: natural gas, coke oven gas, bio-gas,liquid propane gas, diesel, heavy oil, light oil, crude oil

Available industries: Petroleum, chemical, chemical fiber, pharmaceutical, textile printing and dyeing, building materials, wood processing, vegetable oil processing and other industries

  • Product introduction
  • Technical advantages
Introduction

high presure boiler have a three-pass round coil structure. A conical coil is used for the effective protection of the furnace wall at the boiler end. This product is equipped with an advanced combustion device and is fully automated in operation. After the burner ignites the fuel, flame fills the round coil tubes and transfers heat by radiation through the tube wall (first pass). The high temperature flue gas gathers at the back door and then turns to the convection tubes section (second pass), where heat transfer takes place by convection. The flue gas gradually cools down here and flows to the front door, where it is reversed and goes into the third pass. After that, it enters into the chimney through the economizer and is released into the atmosphere.


high presure boiler.This type of heater is delivered as a whole, and is installed on site, it only needs to connect thermal gas(oil) piping and electricity to start operation. The heater has four heating areas: furnace radiation heating area, the first convection tube bundle heating area, the second convection tube bundle heating area and economizer (waste heat boiler).

Digitized manufacture
  • The laying-off of steel tube adopts CNC 3D laser cutting machine.
  • The manufacture of round coil tube adopts CNC coil tube automatic production line. Once-forming and no need for plastic .
Full argon arc welding
  • The tube butt adopts argon arc welding technique and the seams will be done x ray real-time imaging, preventing unqualified seams from entering coil production line .
Easy operation
  • Heater is wholly assembled before delivery, it is easy for installation, debugging and operating.
  • Fully automatic operating, burning, liquid level of high level tank, outlet temperature and flow rate are adjusted automatically and self-protected.
  • The inlet and outlet with end flanges and flanged cover structure facilitate the installation and layout of tubeline in boiler house.
Less fuel consumption
  • Internal side adopts good insulation material, outside uses stainless steel plate, which can mostly reduce heat lost and make working environment better.
  • Multilayers closely spaced tube bundle and steel rod is used to seal and fix, completely eradicating short circuit of flue gas.
  • Before delivery, the residue moisture is removed completely, so the system draining period is reduced to 2 days from 12 days.
Safely operation
  • The inner coil tube has bigger flow rate, so it is more stable under high temperature operation.
  • Conical coil effectively protects the furnace wall at the end of heater and burner on the top.
high presure boiler high presure boiler high presure boiler

High Pressure Boilers Test 1 - ProProfs Qu

Many different industries use High-Pressure boilers for central heating systems and many other applications. A pressure balancing device that prevents the boiler pressure from forcing the water in the boiler into the return lijne is called a? A. Pressure equalizer

lexie@zozen.com > Get A Quote >

High Pressure Boilers | Powertherm | Manufacturer | Water Tube

High Pressure Boiler: Powertherm High pressure boilers (Powertherm) are mostly water tube boilers in which water is on the tube side while flue gases flow across the tubes thereby transferring heat from flue gases to water using cross flow heat transfer. Thermodyne has a vast experience in

lexie@zozen.com > Get A Quote >

High Pressure Boiler - Industrial boiler and power plant boiler

1.High Pressure Boiler hydrostatic test preparation The pressure parts should pass the hydraulically tested after overhaul. The test pressure is the working pressure of the drum, so as to check the tightness of heating surface, steam water pipe and valve. The

lexie@zozen.com > Get A Quote >

How dangerous is it if your boiler pressure is well high? | urban75

2010/2/2 · Our boiler pressure is above the 3 bar mark, we've tried reducing it using the key underneath but to no avail. I'm going to try bleeding the radiators

lexie@zozen.com > Get A Quote >

Re-pressurising your boiler | CORGI HomePl

If it is below one, then your boiler pressure is too low. To top up your system and increase the pressure, you will need to locate your filling loop. This is usually a silver/grey coloured, flexible hose with a small valve at each end,

lexie@zozen.com > Get A Quote >

Is My Boiler Pressure Too High? | Hometr

What happens if my boiler pressure is too high? Just as important as knowing how to increase boiler pressure is knowing how to reduce it, should your boiler pressure gauge start to exceed 3.0. As previously mentioned, if your boiler is consistently running at a

lexie@zozen.com > Get A Quote >

boiler high presu

My Boiler Pressure is Too High? A 24|7 Home Rescue Guide My boiler pressure is too high! Is your boiler pressure too high? If your boiler is still working, you probably shouldn’t worry yourself too much – there likely isn’t anything wrong with the appliance at all, and

lexie@zozen.com > Get A Quote >

Amazon.com: high pressure boil

Piping for High-Pressure Boilers: The Installation and Inspection of High-Pressure Boiler Piping by Steve Kalmbach 4.0 out of 5 stars 3 Paperback $38.95 $ 38. 95 FREE Shipping by Amazon Temporarily out of stock. More Buying Choices $36.99 by and 3.9

lexie@zozen.com > Get A Quote >

high pressure boilers Flashcards and Study Sets | Quizl

Learn high pressure boilers with free interactive flashcards. Choose from 500 different sets of high pressure boilers flashcards on Quizlet. Log in Sign up high pressure boilers Flashcards Browse 500 sets of high pressure boilers flashcards Advanced 24 terms

lexie@zozen.com > Get A Quote >

4 things to look out for in steam boiler pressure controls | 2016-09

The boiler pressure gauge read 12 psi. The boiler operating pressure control was set for 15 psi. . . . Operating pressure control for a boiler. This website requires certain cookies to work and uses other cookies to help you have the best experience. By visiting

lexie@zozen.com > Get A Quote >

High-pressure Boiler Feed Water Pumps Manufacturers,Supplie

GENERAL 1 DESCRIPTION: High-pressure boiler feed water pump series are single stage vertical mixed flow pumps. The high-pressure boiler feed water pump is used to transfer clean water or other liquids with similar physical and chemical properties with water.

lexie@zozen.com > Get A Quote >