boiler for heat and hot water

Industrial boilers

Product thermal capacity: 4-35 t/h

Working pressure: 1.0-2.5 MPA

Outlet temperature: 184-350 ℃

Available fuel: natural gas, coke oven gas, bio-gas,liquid propane gas, diesel, heavy oil, light oil, crude oil

Available industries: Petroleum, chemical, chemical fiber, pharmaceutical, textile printing and dyeing, building materials, wood processing, vegetable oil processing and other industries

  • Product introduction
  • Technical advantages
Introduction

boiler for heat and hot water have a three-pass round coil structure. A conical coil is used for the effective protection of the furnace wall at the boiler end. This product is equipped with an advanced combustion device and is fully automated in operation. After the burner ignites the fuel, flame fills the round coil tubes and transfers heat by radiation through the tube wall (first pass). The high temperature flue gas gathers at the back door and then turns to the convection tubes section (second pass), where heat transfer takes place by convection. The flue gas gradually cools down here and flows to the front door, where it is reversed and goes into the third pass. After that, it enters into the chimney through the economizer and is released into the atmosphere.


boiler for heat and hot water.This type of heater is delivered as a whole, and is installed on site, it only needs to connect thermal gas(oil) piping and electricity to start operation. The heater has four heating areas: furnace radiation heating area, the first convection tube bundle heating area, the second convection tube bundle heating area and economizer (waste heat boiler).

Digitized manufacture
  • The laying-off of steel tube adopts CNC 3D laser cutting machine.
  • The manufacture of round coil tube adopts CNC coil tube automatic production line. Once-forming and no need for plastic .
Full argon arc welding
  • The tube butt adopts argon arc welding technique and the seams will be done x ray real-time imaging, preventing unqualified seams from entering coil production line .
Easy operation
  • Heater is wholly assembled before delivery, it is easy for installation, debugging and operating.
  • Fully automatic operating, burning, liquid level of high level tank, outlet temperature and flow rate are adjusted automatically and self-protected.
  • The inlet and outlet with end flanges and flanged cover structure facilitate the installation and layout of tubeline in boiler house.
Less fuel consumption
  • Internal side adopts good insulation material, outside uses stainless steel plate, which can mostly reduce heat lost and make working environment better.
  • Multilayers closely spaced tube bundle and steel rod is used to seal and fix, completely eradicating short circuit of flue gas.
  • Before delivery, the residue moisture is removed completely, so the system draining period is reduced to 2 days from 12 days.
Safely operation
  • The inner coil tube has bigger flow rate, so it is more stable under high temperature operation.
  • Conical coil effectively protects the furnace wall at the end of heater and burner on the top.
boiler for heat and hot water boiler for heat and hot water boiler for heat and hot water

Heating Domestic Hot Water Using An Outdoor Furna

For a sidearm heat exchanger, the hot line from boiler must first go to the top side port. You can use an outdoor wood burning furnace for heating domestic hot water. You basically have an outdoor wood burning water heater. Have Wood Heating Solutions * *

lexie@zozen.com > Get A Quote >

Boiler for radiant heat and domestic hot water.mov - YouTu

2010/12/19 · Explanation of high efficiency condensing boiler use for both hot water radiant floor heat and domestic hot water.

lexie@zozen.com > Get A Quote >

What's the right boiler for me? - British G

A simple question, but an important one. Some boilers handle demand for lots of hot water better than others. If you have the need for lots of heat and hot water and have a home with a loft or with adequate storage, then a conventional boiler with a storage tank to

lexie@zozen.com > Get A Quote >

what temp to set my boiler for heat and hot water? | DIYnot

2014/1/27 · Hi all Hope you can help Please can you tell me what the general temps for the hot water and heating should be set at? Despite my room stat being set at 25, the rads don't seem to be very hot. It was serviced last week and I'm wondering if the settings were

lexie@zozen.com > Get A Quote >

Difference Between Boiler & Furnace - Slantf

The boiler uses hot water to heat your home. Hot water boilers distribute heat through small hot water pipes using a pump to heat baseboard, cast iron radiators, or radiant flooring systems. A steam boiler distributes steam through a network of pipes to heat the

lexie@zozen.com > Get A Quote >

Hot Water Boilers | In-Floor Heating | Vancouver

Hot Water Boilers BOILERS are appliances that heat water and distribute the water to piping under the floor or to radiators that are installed around the perimeter of the house. In older homes the radiators may be large ornate cast iron fixtures that deliver a warm

lexie@zozen.com > Get A Quote >

Efficient Burnham Boiler for Heat and Hot Water - YouTu

2015/3/30 · Bob visits with Mark Lundquist of Burnham Hydronics to check out the boiler for the hot-water heating system being installed in the Mashpee, Massachusetts, affordable homes.

lexie@zozen.com > Get A Quote >

Boilers Explained | Worcester Bos

A combination or ‘combi’ boiler is both a high efficiency water heater and a central heating boiler in a single compact unit. Combi boilers heat water directly from the mains when you turn on a tap, so you won’t need a hot water storage cylinder or a cold water

lexie@zozen.com > Get A Quote >

What size of boiler do I need for my home? | Viessma

It is very important to choose the right size of boiler for your home to ensure sufficient heat and hot water whilst keeping your fuel bills down. Here's what you should consider.

lexie@zozen.com > Get A Quote >

Can I heat my house with a water heater? Or should I use a boiler

2014/5/2 · Water heaters were designed to heat water for domestic hot water use. They were designed to heat up to 120-140 deg F and run for short periods throughout the day. If your heat demand falls into the design characteristics of a water heater then it may still be 1.

lexie@zozen.com > Get A Quote >

boiler for heat and hot wat

Condensing Hot Water Boiler Introduction Vacuum hot water boiler is an ideal solution for heating supply. Gas is available to be used in the heating boiler. There is completely deoxy purified water in the furnace, More Get a quote Electric Hot Water Boiler

lexie@zozen.com > Get A Quote >