wht is package 3 pass fire tube boiler?

Industrial boilers

Product thermal capacity: 4-35 t/h

Working pressure: 1.0-2.5 MPA

Outlet temperature: 184-350 ℃

Available fuel: natural gas, coke oven gas, bio-gas,liquid propane gas, diesel, heavy oil, light oil, crude oil

Available industries: Petroleum, chemical, chemical fiber, pharmaceutical, textile printing and dyeing, building materials, wood processing, vegetable oil processing and other industries

  • Product introduction
  • Technical advantages
Introduction

wht is package 3 pass fire tube boiler? have a three-pass round coil structure. A conical coil is used for the effective protection of the furnace wall at the boiler end. This product is equipped with an advanced combustion device and is fully automated in operation. After the burner ignites the fuel, flame fills the round coil tubes and transfers heat by radiation through the tube wall (first pass). The high temperature flue gas gathers at the back door and then turns to the convection tubes section (second pass), where heat transfer takes place by convection. The flue gas gradually cools down here and flows to the front door, where it is reversed and goes into the third pass. After that, it enters into the chimney through the economizer and is released into the atmosphere.


wht is package 3 pass fire tube boiler?.This type of heater is delivered as a whole, and is installed on site, it only needs to connect thermal gas(oil) piping and electricity to start operation. The heater has four heating areas: furnace radiation heating area, the first convection tube bundle heating area, the second convection tube bundle heating area and economizer (waste heat boiler).

Digitized manufacture
  • The laying-off of steel tube adopts CNC 3D laser cutting machine.
  • The manufacture of round coil tube adopts CNC coil tube automatic production line. Once-forming and no need for plastic .
Full argon arc welding
  • The tube butt adopts argon arc welding technique and the seams will be done x ray real-time imaging, preventing unqualified seams from entering coil production line .
Easy operation
  • Heater is wholly assembled before delivery, it is easy for installation, debugging and operating.
  • Fully automatic operating, burning, liquid level of high level tank, outlet temperature and flow rate are adjusted automatically and self-protected.
  • The inlet and outlet with end flanges and flanged cover structure facilitate the installation and layout of tubeline in boiler house.
Less fuel consumption
  • Internal side adopts good insulation material, outside uses stainless steel plate, which can mostly reduce heat lost and make working environment better.
  • Multilayers closely spaced tube bundle and steel rod is used to seal and fix, completely eradicating short circuit of flue gas.
  • Before delivery, the residue moisture is removed completely, so the system draining period is reduced to 2 days from 12 days.
Safely operation
  • The inner coil tube has bigger flow rate, so it is more stable under high temperature operation.
  • Conical coil effectively protects the furnace wall at the end of heater and burner on the top.
wht is package 3 pass fire tube boiler? wht is package 3 pass fire tube boiler? wht is package 3 pass fire tube boiler?

New Yorker Boiler Company | Manufacturer of Residentia

About New Yorker Boiler Company. New Yorker Boiler Company, manufacturer of reliable residential hydronic-heating products, offers a complete line of cast …

lexie@zozen.com > Get A Quote >

Factory Acceptance Testing Guideline -

circumstance in which a person is exposed to hazard(s) (3.1.3 in IEC 61508-4) hazardous event hazardous situation which results in harm (3.1.4 in IEC 61508-4) harm physical injury or damage to the health of people, either directly or indirectly, as a result of damage to property or to the environment (3.2.30 in IEC 61511-1) instrument

lexie@zozen.com > Get A Quote >

Biomass Fired Hot Water Boiler in Indonesia – CFBC Boile

HOKEN Janner Boiler. A three pass coal fired chain grate Fire Tube Boiler. Fully Water cooled with high heating surface and high boiler efficiency for low and high calorific coal. Our standard production capacity is 5,000 – 16,000 kg/hr. CFB. Our design and fabrication is according to ASME S Stamp or other equivalent code.

lexie@zozen.com > Get A Quote >

Economizer - Wikiped

This is the reverse arrangement to that usually but not always seen in the fire tubes of a boiler; there the hot gases usually pass through tubes immersed in water, whereas in an economizer the water passes through tubes surrounded by hot gases.

lexie@zozen.com > Get A Quote >

Burnham Commercial Boilers - America's leadin

Burnham Commercial, America's leading manufacturer and marketer of high-quality boilers and control systems for commercial and industrial applications as well as Water Heaters, High Efficiency systems, and Control Systems for Commercial Use.

lexie@zozen.com > Get A Quote >

Boiler Efficiency - Engineering ToolB

Boiler efficiency may be indicated by. Combustion Efficiency - indicates a burners ability to burn fuel measured by unburned fuel and excess air in the exhaust; Thermal Efficiency - indicates the heat exchangers effectiveness to transfer heat from the combustion process to the water or steam in the boiler, exclusive radiation and convection losses; Fuel to Fluid Efficiency - indicates the

lexie@zozen.com > Get A Quote >

WatchESPN: Live Sports, Game Replays, Video Highligh

Stream live sports, watch game replays, get video highlights, and access featured ESPN programming on your computer, mobile device, and TV with WatchESPN.

lexie@zozen.com > Get A Quote >

How do heat exchangers work? - Explain that Stu

12/8/2018 · All heat exchangers do the same job—passing heat from one fluid to another—but they work in many different ways. The two most common kinds of heat exchanger are the shell-and-tube and plate/fin. In shell and tube heat exchangers, one fluid flows through a set of metal tubes while the second fluid passes through a sealed shell that surrounds

lexie@zozen.com > Get A Quote >

WETBACK DESIGN vs HARD REFRACTORY DRYBACK DESI

WETBACK DESIGN vs HARD REFRACTORY DRYBACK DESIGN WHY IS A WETBACK DESIGN BETTER? As indicated in the drawing, a three-pass wetback design has a rear water wall, which separates the primary heating surface of the combustion chamber from the rear tube sheet. The water jacket eliminates the need for a refractory wall

lexie@zozen.com > Get A Quote >

How VAV Boxes Work | [HVAC Commercial Zonin

How VAV Boxes Work? A Variable Air Volume box is typically installed in commercial buildings and provide heating and cooling for occupants. There are different types of Variable Air Volume boxes but how a Variable Air Volume box works is fundamentally …

lexie@zozen.com > Get A Quote >

What If My Furnace Heat Exchanger Is Ba

1. What is a Heat Exchanger? The heat exchanger in a furnace separates the combustion process from your breathing air. It is a combination metal chamber and passageway that starts at the burner assembly and ends approximately where the chimney vent connects to the furnace.

lexie@zozen.com > Get A Quote >