Fluidized Bed Power Plant

Industrial boilers

Product thermal capacity: 4-35 t/h

Working pressure: 1.0-2.5 MPA

Outlet temperature: 184-350 ℃

Available fuel: natural gas, coke oven gas, bio-gas,liquid propane gas, diesel, heavy oil, light oil, crude oil

Available industries: Petroleum, chemical, chemical fiber, pharmaceutical, textile printing and dyeing, building materials, wood processing, vegetable oil processing and other industries

  • Product introduction
  • Technical advantages
Introduction

Fluidized Bed Power Plant have a three-pass round coil structure. A conical coil is used for the effective protection of the furnace wall at the boiler end. This product is equipped with an advanced combustion device and is fully automated in operation. After the burner ignites the fuel, flame fills the round coil tubes and transfers heat by radiation through the tube wall (first pass). The high temperature flue gas gathers at the back door and then turns to the convection tubes section (second pass), where heat transfer takes place by convection. The flue gas gradually cools down here and flows to the front door, where it is reversed and goes into the third pass. After that, it enters into the chimney through the economizer and is released into the atmosphere.


Fluidized Bed Power Plant.This type of heater is delivered as a whole, and is installed on site, it only needs to connect thermal gas(oil) piping and electricity to start operation. The heater has four heating areas: furnace radiation heating area, the first convection tube bundle heating area, the second convection tube bundle heating area and economizer (waste heat boiler).

Digitized manufacture
  • The laying-off of steel tube adopts CNC 3D laser cutting machine.
  • The manufacture of round coil tube adopts CNC coil tube automatic production line. Once-forming and no need for plastic .
Full argon arc welding
  • The tube butt adopts argon arc welding technique and the seams will be done x ray real-time imaging, preventing unqualified seams from entering coil production line .
Easy operation
  • Heater is wholly assembled before delivery, it is easy for installation, debugging and operating.
  • Fully automatic operating, burning, liquid level of high level tank, outlet temperature and flow rate are adjusted automatically and self-protected.
  • The inlet and outlet with end flanges and flanged cover structure facilitate the installation and layout of tubeline in boiler house.
Less fuel consumption
  • Internal side adopts good insulation material, outside uses stainless steel plate, which can mostly reduce heat lost and make working environment better.
  • Multilayers closely spaced tube bundle and steel rod is used to seal and fix, completely eradicating short circuit of flue gas.
  • Before delivery, the residue moisture is removed completely, so the system draining period is reduced to 2 days from 12 days.
Safely operation
  • The inner coil tube has bigger flow rate, so it is more stable under high temperature operation.
  • Conical coil effectively protects the furnace wall at the end of heater and burner on the top.
Fluidized Bed Power Plant Fluidized Bed Power Plant Fluidized Bed Power Plant

CFB: Technology of the Future? - Power Engineeri

Fuel flexibility and a smaller carbon footprint are behind renewed interest in circulating fluidized bed as part of the Authority’s plan to repower its Lamar Light and Power plant. The unit

lexie@zozen.com > Get A Quote >

FLUIDIZED COMBUSTION - Politechnika Wrocławs

COMBUSTION AND FUELS Fluidized bed-combustion features a) direct contact of particles withintensivemass and heat exchange, b) uniform temperature in the fluidized bed c) high heat capacity of fluidized bed makingitpossible to burn fuels of low quality, wet and with high content of ash d) effectiveness of bed temperature control by supply of

lexie@zozen.com > Get A Quote >

Fluidized Bed Boilers - YouTu

2/2/2016 · Conventional solid fuel power boilers burn the fuel in a fixed bed. In a fluidized bed boiler, hot air is blown at a high velocity up through a bed of sand, limestone, and ash causing the solid

lexie@zozen.com > Get A Quote >

Circulating Fluidized Bed Coal Fired Power Plant Boile

Circulating fluidized bed (CFB) technology has established its position as a power plant boiler technology.high efficiency CFB power plants to utilize the supercritical steam parameters in coal firing with once-though steam cycle technology.coal-fired circulating fluidized bed technology is the dominant technology for coal-fired power plant

lexie@zozen.com > Get A Quote >

11.5 MWe Fluidized Bed Power Plant Using Refuse-Derive

11.5 MWe Fluidized Bed Power Plant Using Refuse-Derived Fuel (RDF) 11.5 MWe Fluidized Bed Power Plant Using Refuse-Derived Fuel (RDF) Outotec’s bubbling fluidized bed technology is ideally-suited to cope with challenging fuels, such as RDF.

lexie@zozen.com > Get A Quote >

FLUIDIZED BED COMBUSTION - electrical power generati

FLUIDIZED BED COMBUSTION. While the pulverized coal-fired boiler represents the most efficient type of coal- fired power plant, there are alternatives. One of these is the fluidized bed boiler. This type of combustion system is capable of burning a much wider range of fuels than a PC plant.

lexie@zozen.com > Get A Quote >

Technology - RP Ener

Home / The Power Plant / Technology. Technology. Circulating Fluidized Bed Technology. RP Energy will use the environment-friendly Circulating Fluidized Bed (CFB) technology. This is the technical term for the new generation of environment-friendly coal technology to generate power that meets stringent health, safety and environmental protection standards.

lexie@zozen.com > Get A Quote >

Fluidized Bed Boiler for 10 MW Biomass Power Pla

For a 10 MW biomass power plant, the fluidized bed boiler is the better choice for burning biomass because it transfers the heat of combustion into steam as the driving force.

lexie@zozen.com > Get A Quote >

Circulating Fluidized-Bed Boilers - babcock.c

Drawing upon our extensive technical expertise and operating experience, B&W developed the Internal Recirculation Circulating Fluidized-Bed (IR-CFB) boiler which is the technology of choice for power plant owners seeking economy, reliability and flexibility. In addition, load-following capabilities are attainable with B&W’s in-bed heat exchanger technology.

lexie@zozen.com > Get A Quote >

Circulating Fluidized Bed Boiler | CFB Boiler | GE Pow

Ultra-Supercritical Circulating Fluidized Bed (CFB) Boilers. 660 MWe for lignite B, higher for hard coal, for low-grade and difficult-to-burn fuels such as anthracite, lignite, petroleum coke, oil shale, discarded coal and biomass, GE offer circulating fluidized bed technologies with …

lexie@zozen.com > Get A Quote >

Advantages of Fluidized Bed Combustion Boilers -

10/3/2017 · The site is about power plant engineering and power technology. This site has covered many topics of related to boiler & turbine operation and it's Maint. Advantages of Fluidized Bed Combustion Boilers:- Today we discussed about the Fluidized Bed Combustion Boilers advantages. Here a list of Fluidized Bed Combustion Boilers is given below

lexie@zozen.com > Get A Quote >